Eco-Friendly
Safe formulations that are gentle on the environment.
Vibrant Colors
A wide palette to enhance your space’s beauty.
Easy Application
User-friendly products for smooth application.
Durability
Designed to withstand harsh conditions for lasting protection.
INTENDED USES
Pro HomeGuard is recommended for all types of interior masonry surfaces such as brickwork, plaster, cement rendering, and wallboards.
FEATURES
- Resistant to Humidity: Effective against atmospheric humidity levels in normal interior environments.
- Washability: Highly washable for easy maintenance.
- Excellent Coverage: Provides an outstanding finish with minimal coats.
- Low VOCs: Environmentally friendly with low volatile organic compounds.
PRODUCT INFORMATION
- Appearance: Matt Finish
- Colour: Wide range of ready-mix colors
- Binder Type: Acrylic copolymer
- Pigment Type: Light Fast Non-Lead Pigments
- Application: Brush, Roller, and Spray
- Flash Point: Not Applicable
- Cleaning: Clean all equipment with clean water immediately after use
- Thinning: 25–30%
- Coverage: 12 - 13 m²/Liter/coat (Actual spreading rate depends on film thickness applied, surface porosity, imperfections, temperature, wastage, etc.)
- Specific Gravity: 1.50 ± 0.02
- Volume Solids (Theoretical): 37 ± 2% for Brilliant White (other colors will vary)
- No. of Coats: 2-3
- Film Thickness:
- Wet: 80-90 µm/lit/coat
- Dry: 30-35 µm/lit/coat
- Packing: 1, 4, and 16 Liters
DRYING INFORMATION
| Temperature | Touch Dry | Hard Dry | Recoat |
|---|---|---|---|
| 5°C | 6 hrs | 12 hrs | 12 hrs |
| 15°C | 2 hrs | 6 hrs | 6 hrs |
| 25°C | 1 hrs | 3 hrs | 3 hrs |
| 35°C | 0.5 hrs | 1.5 hrs | 1.5 hrs |
Drying and recoat times are temperature, humidity, and film thickness dependent.
SURFACE PREPARATION AND APPLICATION
Appropriate and good surface preparation significantly increases the top coat life and durability. Efflorescence or mould must be treated before the application of paint. Treat any areas affected by mould, lichens, algae, or moss with bleach. Deploy skilled and experienced individuals for the application of paint. Below are a few general instructions:
New or Bare Surfaces:
New concrete, mortar, or cement render must be allowed to cure for 8-12 weeks depending on concrete thickness and drying conditions. The surface to be painted must be dry, clean, and free from all contamination and efflorescent salts. Remove dirt, grease, and waxy material by rubbing down using suitable abrasive paper. Apply one coat of Pro Plaster Primer and two coats of Pro Wall Skim. A third coat of Pro Wall Skim can be applied for extra smoothness. Allow the surface to dry completely, scuff with suitable abrasive paper, and dust off. For best results, apply one coat of Pro Plaster Primer over Pro Wall Skim before the application of Pro HomeGuard.Previously Painted Sound Surfaces:
Scrape off all loosely adherent and defective paint from the surface with appropriate abrasive paper or a stiff brush and dust off. Spot prime with Pro Plaster Primer and fill surface imperfections with Pro
Reviews
There are no reviews yet.